Simrad SX90 Quick Start Manual page 18

Simrad SX90 Quick Start Guide
your Operating Panel to control more than two sonars, press
to select.
: Press one of the
C
User Settings
To choose which function to apply open the
, assign one predefined setting to each button on the Operating Panel. The
Buttons
Operating Panel
: Press one of the
D
F1 F2 F3
function to apply open the
function to each
: Press this button to make a copy of the current SX90 presentation. You
Screen Capture
can choose either a single screen capture or a sequence with multiple screen captures.
Open the
Screen Captures
: Press the joystick forward to increase the tilt angle in the active view. Turn
E
Joystick
the button on the top of the joystick to change the bearing in the active view.
: These buttons correspond to the two most common buttons on a
F
Mouse buttons
standard computer mouse. When an instruction tells you to "select" or "left-click", press
the left button. When an instruction tells you to "right-click", press the right button.
Use these buttons to lower and hoist the transducer. While the transducer is moving the
G
indicator lamp flashes, and an audible signal is sounded. When the requested position
has been reached, the indicator lamp is lit, and the audible signal stops.
• : Press
Up Up
• : Press
Middle
• : Press
Down
H : Turn a rotary switch to apply a predefined function. To choose which
Rotary switches
function to apply open the
one function to each rotary switch on the Operating Panel.
I Use these buttons to place markers in the current active view.
• : Press
Marker
markers can be placed in the view to identify specific echoes. Each marker is shown
as a small triangle with or without a short identifying label. It is positioned based on
the two known axes in the view as well as the tilt and bearing of the current ping.
• : Press
Circle Marker
circle is drawn with the same diameter as your purse. By means of the circle you
can see the size of the school relative to your purse.
• : Press
Gear Gear
provided as a tool to help you plan and shoot the purse seine. The symbol is intended
to be used in a structured sequence that starts when you plan to shoot the purse seine.
Press these buttons to start position or target tracking.
J
16
User Settings
page is located in the
buttons to apply a predefined function. To choose which
Fx
Operating Panel
button on the Operating Panel.
Fx
dialog box to select screen capture mode.
to hoist the transducer to its upper position.
to place the transducer in a predefined middle position.
Middle
to lower the transducer to its bottom position.
Down
Operating Panel
to place a generic marker in the active view. One or more
Marker
to place a circular marker in the active view. The
Circle Marker
to place a gear symbol in the active view. The gear symbol is
buttons to apply a predefined user setting.
Operating Panel
dialog box.
Installation
page. Under
Button Options
page. Under
Rotary Switch Options
repeatedly
Sonar Select
page.Under
User Setting
, assign one
, assign
386619/C