Simrad SX90 Quick Start Manual page 9

Simrad SX90
When the SX90 is not used
When you do not use the SX90, turn off the entire system.
Note
You must never turn off the SX90 by means of the on/off switch on the Processor Unit.
You must ALWAYS use the Operating Panel.
When you are docking your vessel
You must never set the SX90 to normal operation when the ship is in dry dock. The
transducer may be damaged if it transmits in open air. To prevent inadvertent use of the
SX90, pull out the mains plug on the Processor Unit whenever your vessel is in dry dock.
Additional precautionary measurers should be considered.
If something breaks down
If you believe that something has broken down, contact your local dealer. A list of all our
dealers is provided on our website.
• https://www.simrad.com
If you are unable to contact a dealer, observe the support information in this publication.
When you want to turn off the SX90
You must never turn off the SX90 by means of the on/off switch on the Processor Unit.
When you do not use the SX90, turn it off with the button on the Operating Panel.
Power
If the transducer is lowered when you turn off the SX90, it is automatically retracted to
its upper position.
Note
If you turn off the SX90 by means of the on/off switch on the Processor Unit you may damage
the software and the interface settings used to communicate with external devices.
Manual operation of the hull unit
In the event of improper operation, the powerful electric motor on the hull unit may cause
serious damage to the equipment and/or injury to personnel. Therefore, before you start
manual operation, read carefully through the relevant operating procedures.
Note
You must familiarize yourself with the correct handling methods and the relevant safety
requirements.
7
386619/C