Table of Contents
Advertisement
CLEANING
1.
Remove all loose debris. Construction plaster or excess
grout can be removed with the use of a wood (edge) trowel.
2. Paint or tar stains may need to be removed with a cleaner
such as paint thinner, turpentine, or isopropyl alcohol (rubbing
alcohol). Never allow the cleaner to soak against the acrylic
surface for long periods of time. Always rinse the surface
immediately following the use of cleaners.
3. Follow the manufacturer's instructions for safe use of cleaning
products. If the surface becomes scratched or dulled, it
may be restored by using a quality plastic polish, like Novus
Plastic Polish No. 2 (available from the Jason Dealer). It is
always preferable to protect the acrylic surface during
installation to minimize cleanup and prevent surface
damage.
Jason International, Inc. • 501.771.4477
INSTALLATION INSTRUCTIONS (cont.)
WATER TESTING
Before finishing the installation, it is recommended that the bath be
water tested and the plumbing tested for leaks.
1.
Before water-testing the bath, make sure any pump unions
are hand tight. Do not over tighten or use a pipe wrench. This
will damage the unions and cause leaking. If the unit leaks with
the unions hand tight, then loosen the unions(s) and check the
O-ring seal to ensure it is properly seated.
2. Fill and operate the bath. Close the drain and fill the bath
with water to at least 10 inches [25 cm] below the bath deck.
The inlet temperature should not exceed 40°C (104°F). Refer
to the FILLING AND DRAINING section of this owner's manual
for more information.
NEVER RUN THE PUMP WITHOUT ENOUGH WATER IN
THE BATH TO COVER THE JETS.
3. Inspect the plumbing for leaks.
4. Turn the equipment Off and then drain the water. The
bath unit and its plumbing are designed to drain after each
use whether used as a hydrotherapy bath, soaking bath, or
when taking a shower.
Page 7 of 16
Customer Service : 800.255.5766
Copyright © 2014 Jason International
Advertisement
Table of Contents
