JASON Hydrotherapy Forma AirMasseur AC635P Owner's Manual

"TO BE REMOVED FOR USE BY THE OCCUPANT."
Jason International, Inc.
8328 MacArthur Drive
North Little Rock, AR 72118
www.jasoninternational.com
INsTallaTION, OPeraTION, aND MaINTeNaNCe
INSPECTION
Inspection of the unit prior to installation is the responsibility
of the installer. All components are assembled to the
bath and the unit is water tested and inspected prior to
leaving Jason International, Inc. If the carton shows sign of
damage, inspect the product before accepting and describe
the problem on the Bill of Lading. Note: Transportation
and insurance from Jason's factory are the buyer's
responsibility.
Damage sustained in transit is the responsibility of the carrier.
If damage is discovered, the carrier must be immediately
notified in writing with a request for a representative to
inspect the unit. Failure of the carrier to respond should be
reported to the seller and carrier. Always file a freight claim
promptly.
The installer is responsible for insuring that the unit is
free from defects or shipping damage. In the event of a
problem, DO NOT install the unit. Jason International is not
responsible for damage that might have been avoided by
inspection or testing prior to installation.
Damage to the unit during installation will not be covered
by warranty and is the responsibility of the installer. ALL
WARRANTY CLAIMS ON ACRYLIC SURFACE DAMAGE
OwNer's reCOrD
Dealer:
Date Purchased:
Date Installed:
Installer:
Jason International, Inc. • 501.771.4477
OwNer's MaNual
AC635P forma™ AirMasseur
CAUTION: DO NOT LIFT OR HANDLE THE BATH BY ITS PLUMBING.
MUST BE MADE PRIOR TO INSTALLATION. Inspect
plumbing and bath surface for missing or damaged
components. Alert your dealer of any discrepancies.
To protect the unit from damage keep the unit in its carton
until ready for installation.
EQUIPMENT ACCESS
In accordance with Building Codes, service access
to all therapy bath equipment, controls, and electrical
connections must be provided during installation. (See Table
1 - Specifications for minimum access size). .) Insufficient
access will hinder repair and maintenance. Warranty service
will not cover the cost of providing equipment access.
TABLE 1 - SPECIFICATIONS
Overall
Dimension
Model L x W x H (in.)
AC635P 42 x 72 x 22
PlaCe serIal NuMBer CarD wITH
PrODuCT CONFIGuraTION IN THIs BOx
Page 1 of 15
Bath
®
Operating Blower Min. Size
Capacity 120v / Access
Gal 240v HP W x H (in.)
56 1 36 x 17
Customer Service : 800.255.5766
49-1000-113
Date 11/07
Floor
Loading
lbs/ft
2
53.8 lbs