VPC i2 MICRO iCON User Manual page 7

i2 MICRO iCON USER MANUAL
TOOLS REQUIRED
Phillips Head Screwdriver
Flat Head Screwdriver
INSTALLATION INSTRUCTIONS
1. With the needed wires/contacts installed in the i2 Micro iCon
ITA/module, distribute the wires evenly around the drive shaft
(Figure A).
2. Place the cable bundle in the u-shaped cable clamp portion
of the cover and position the cover against the wiring side of
the ITA/module (Figure B).
3. With the cover against the wiring side of the ITA/module, slide
the cover down so that the slot for the cover insert clears the
bottom of the ITA/module (Detail A in Figure C).
4. Slide the insert into the cover in the orientation shown
(Figure C).
Continued on next page...
Figure A. Distribute wires evenly around drive shaft.
6
ITA COVER INSTALLATION
PART # 410 130 XXX
Figure B. Position cover.
Figure C. Slide cover down and install insert.
For more information visit vpc.com
VPC
RETURN TO INDEX
07/23/21