VPC i2 MICRO iCON User Manual page 17

i2 MICRO iCON USER MANUAL
16.26
.640
1.78
.070
PIN A1
8.76
.345
33.02
1.300
1
13 EQ. SPCS.
@ [2.54] .100
49.53
1.950
100.08
3.940
(Figure A) PCB layout for i2 receiver, Part # 310 130 101. Through
hole and pad diameters are for VPC QuadraPaddle male Adapter
Contact, Part # 610 138 117. The size of these holes may be different
if a header from a different manufacturer is used. Connector
mounts this side.
(Figure C). Twin male header.
NOTE: (Figure C) details 0.22" [5.59 mm]/0.45" [11.43
mm] min/ max engagement.
NOTE: Minimum spacer height = 0.24" + header carrier
height - panel thickness (if used).
Any additional height beyond this minimum must be
added to the header post limits shown in (Figure C).
NOTE: Several manufacturers offer the twin male
header: Samtec, TE, MultiComp, Molex. The specific
part number required is dependant on the distance the
i2 will be located from the PCB, the thickness of the
PCB, and the plating type required.
16
STANDARD PCB LAYOUT
i2 RECEIVER • PART # 310 130 101
12.70
.500
5 EQ. SPCS.
@ [2.54] .100
1
RECOMMENDED PCB LAYOUT
CONNECTOR MOUNTS THIS SIDE
TOLERANCES ARE:
.XX = [.25].01
.XXX = [.13].005
UNLESS OTHERWISE SPECIFIED
1
.0021 LOCATION TOLERANCES
APPLIES TO PLATED THROUGH HOLES
PIN F1
0.94±0.08
.037±.003
PLATED THROUGH HOLE
TYP. 168 PLCS.
.060 PAD
TYP. 168 PLCS.
2.54
.100 THROUGH
0.22" [5.6 mm] /
0.45" [11.4 mm]
HEADER CARRIER HEIGHT
For more information visit vpc.com
(Figure B) i2 receiver, Part # 310 130 101, loaded
with twin female contacts, Part # 610 138 200.
Twin male headers are used to connect the female
contacts to the PCB plated through holes.
HEADER, .100" SPACING TWIN MALE
SOLDERED TO PCB CREATES A
SEPERABLE INTERFACE
i2 RECEIVER
(Figure D) A PCB can be mounted directly to the back of an i2 receiver as
shown above. Four 2-56 or M2 screws are required to mount the receiver.
Spacers may be needed to prevent unwanted stress on the PCB.
VPC
PCB
SPACER (SEE NOTE)
RETURN TO INDEX
07/23/21