Receiver Mounting - VPC i2 MICRO iCON User Manual

i2 MICRO iCON USER MANUAL
TOOLS REQUIRED
Phillips Head Screwdriver
MOUNTING INSTRUCTIONS
1. Prepare the mounting surface using the dimensions
provided in (Figure A).
2. Attach the i2 Micro iCon receiver to the panel with the
provided 2-56 Phillips head screws and nuts (Figure B).
Torque screws to 2 in-lbs [0.23 Nm].
NOTE: If the mounting surface is thicker than 0.125"
[3.18 mm], longer screws may be needed.
NOTE: If the mounting surface has threaded holes, the nuts
will not be needed.
NOTE: M2 hardware can be used in place of the provided
2-56 hardware.
NOTE: The dimensions shown reflect use of a laser cutting
or punch press process. If using conventional machining
5
processes the 3.49" [88.65] dimension will be 3.69" [93.73]
and a .09" [2.29] radius needs to be added to the corners.
Figure B. If metric hardware is preferred, the supplied 2-56 hardware can be
replaced with M2 hardware.
4

RECEIVER MOUNTING

PART # 310 130 XXX
5.7
.23
100.07
3.940
88.6
5
3.49
5 TYP.
TOLERANCES ARE:
.XX = [.25].01
.XXX = [.13] .005
UNLESS OTHERWISE SPECIFIED
Figure A. Recommended panel cutout.
For more information visit vpc.com
4
16.26
.640 TYP.
1.27
.050 TYP.
4.8 9.1
.19 TYP. .36 TYP.
18.8
.74
TABLE 1
PART NUMBER DESCRIPTION
410130101 ITA, i2 Micro iCon, 168 Position
410130104 ITA, i2 Micro iCon, 120/12 Position Hybrid
ITA, i2 Micro iCon, 168 Position with
410130106
Oversized Backshell
ITA, i2 Micro iCon, 120/12 Position Hybrid
410130115
with Oversized Backshell
4 SEE TABLE 1 FOR MINIMUM DISTANCE OF SUBSEQUENT SIDE BY SIDE CUTOUTS.
*SPACING IS APPLICATION SPECIFIC, .80" MINIMUM, 1.00" RECOMMENDED
VPC
FOR MOUNTING PLATES .09" THICK OR LESS
.100 THRU, TYP. 4 PLCS
FOR MOUNTING PLATES THICKER THAN .09"
.086-56UNC-2B THRU, TYP. 4 PLCS.
2.3
R.09 TYP.
RECEIVER CUTOUT
SPACING
1.00 [25.40]
1.00 [25.40]
2.19[55.63]
2.19[55.63]
RETURN TO INDEX
07/23/21