VPC i2 MICRO iCON User Manual page 4

i2 MICRO iCON USER MANUAL
ENGAGEMENT INSTRUCTIONS
1. Turn the engagement knob counter-clockwise to the open/
disengaged position (Figure A).
2. Align the i2 Micro iCon ITA with the receiver and gently push the
ITA onto the receiver. There will be about a 0.25" [6.35 mm] gap.
NOTE: The ITA is polarized and will not align if it is upside down.
NOTE: The ITA can be left in this position without engaging the
system.
Rotate the engagement knob clockwise to engage (Figure B).
3.
NOTE: For optimum performance and system longevity,
distribute the contact load evenly. 3/ 3 2 3/ 3 2
DISENGAGEMENT INSTRUCTIONS
1. Turn the engagement knob counter-clockwise to the open/
disengaged position (Figure A).
2. Remove the ITA by gently pulling backwards.
NOTE: For unbalanced loads, add force to the lower pin load
during disengagement to prevent binding.
3
RECEIVER/ITA ENGAGEMENT AND DISENGAGEMENT
RECEIVER • PART # 310 130 XXX
ITA • PART # 410 130 XXX
For more information visit vpc.com
Figure A. Disengaged ITA and receiver.
Figure B. Engaged ITA and receiver.
VPC
RETURN TO INDEX
07/23/21