Motor - Husqvarna K7000 Workshop Manual

2
1 2
4 5
8
1
6
4
5
4
6

MOTOR

Removal
Front motor guard
The front motor guard must be removed in order to access the
motor itself and the electrical connections to it.
First, remove the rear guard and the control unit as described on
page 5.
1. Remove the vibration element's inner screw, 4 mm Allen.
(3–4 Nm)
2. Remove the screw by the ground support. (MT6x45, 4–5 Nm)
3. Remove the screw for the guard. (MT5x14, 3–4 Nm). Lift off the
guard.
4. Split the connectors to the motor.
5. Remove the hose clip and pull off the hose that passes to the
water connection.
6. Remove the hose to the motor from the water valve.
7. Turn the machine. Remove the two belt guard guards and lift
off the cutting head. This is described on page 9.
8. The motor is secured to the cutting arm with four screws.
Remove the screws. The motor can then be lifted out.
(M5x12, 7–8 Nm)
Do not dismantle the motor!
A defective motor cannot be reconditioned without specialist
expertise and special tools. The entire motor must be replaced if
the motor is defective.
4
7