Download Print this page

Controls, Electrical Components - Husqvarna K7000 Workshop Manual

Hide thumbs Also See for K7000:

Advertisement

CONTROLS, ELECTRICAL COMPONENTS

1
3
Green
Brown
White
Yellow
2
4
2a
2
5
4
3
Grey
Removal
Rear motor guard
Remove the screws indicated with arrows, then remove the guard.
(7 x MT5x14, 3–4 Nm. 1 x MT5x40, 3–4 Nm)
When the guard has been removed, most components are accessible,
such as the control unit with electrical connections, the water valve
and hoses.
Motor bracket
The motor bracket connects the motor to the low-vibration handle
unit.
1. Remove the three inner screws. (3 x M5x26, 7–8 Nm)
2. Remove the two outer screws. (2 x M6x40, 5–6 Nm)
3. Lift off the motor bracket.
To continue removal, see page 7.
Control unit
1. Remove the knob for the water valve by unscrewing it.
2. Note how the return spring for the starter inhibitor is fitted and
tensioned.
3. Lift off the control unit.
4. Turn the control unit so that the electrical connections on the
back can be accessed.
Electrical connections
Pay attention to the cable colours on the connections so that these
can be connected to the correct contact positions when refitted.
The three pin connectors 3, 4 and 5 are removed by pulling them
out.
3
5

Hide quick links:

Advertisement

loading