Motor - Husqvarna K7000 Ring Workshop Manual

Hide thumbs Also See for K7000 Ring:

Table of Contents

MOTOR

Removal

Starting position

Remove the blade as described on Page 6.

Remove the rear motor guard as described on Page 26.

Remove the transmission housing and belt as illustrated and descri-

bed on Page 18.

The front motor guard must be removed to access the motor itself

and its electrical connections. The motor bracket must first be

removed.

Motor bracket

The motor bracket connects the motor to the anti-vibration handle

unit.

1. Remove the three inner screws. (3 x M5x26, 7–8 Nm)

2. Remove the two outer screws. (2 x M6x40, 5–6 Nm)

3. Lift off the motor bracket.

Front motor guard

1. Remove the inner anti-vibration element screw,

4 mm Allen (3–4 Nm).

2. Remove the screw by the handle bracket. (MT6x45, 4–5 Nm)

3. Remove the guard screw. (MT5x14, 3–4 Nm). Lift off the guard.

4. Remove the water control valve by unscrewing the knob.

Troubleshooting – testing motor functions

There is a chapter headed TROUBLESHOOTING at the end of

the workshop manual. This shows how to carry out trouble -

shooting with the motor and electrical components disassembled –

this is in order to clearly illustrate how tests are to be carried out.

Note that the motor need not be dismantled for this trouble -

shooting operation. All electrical connectors and other electrical

components are accessible for inspection when the machine has

been disassembled to the extent detailed on this page and as

illustrated on the left.

Table of Contents