Tools And Accessories; Type Vcp-W Vacuum Circuit Breaker Weights (Table 3.1); Vcp-W Circuit Breaker Weights - Eaton Cutler-Hammer VCP-W Instructions For Installation, Operation And Maintenance

I.B. 3A74792H04
check, leave the closing springs "discharged" and circuit
breaker contacts "open".
Outdoor storage is NOT recommended. If unavoidable,
the outdoor location must be well drained and a tempo-
rary shelter from sun, rain, snow, corrosive fumes, dirt,
falling objects and excessive moisture must be provid-
ed. Containers should be arranged to permit free circu-
lation of air on all sides and temporary heaters should
be used to minimize condensation. Moisture can cause
rusting of metal parts and deterioration of high voltage
insulation. A heat level of approximately 400 watts for
each 100 cubic feet of volume is recommended with the
heaters distributed uniformly throughout the structure
near the floor.
Indoor storage should be in a building with sufficient
heat and air circulation to prevent condensation. If the
building is not heated, the same general rule for heat as
for outdoor storage should be applied.

3-5 TOOLS AND ACCESSORIES

Several tools and accessories, both standard and
optional are available for use with the circuit breaker.
Maintenance Tool (Standard): Used to charge closing
springs.
Lifting Yoke (Optional): Used to lift circuit breaker with
overhead lifting device.
Fifth Wheel (Optional): Used to maneuver a circuit
breaker on a flat, hard surface (Figure 3-3).
Effective 7/97
3-6 TYPE VCP-W VACUUM CIRCUIT BREAKER
WEIGHTS (TABLE 3.1)
Table 3.1 VCP-W Circuit Breaker Weights
Rating
380 VCP-W 16
1200
1600
2000
380 VCP-W 25
1200
1600
2000
380 VCP-W 32
1200
1600
2000
380 VCP-W 20 1200
2000
Does not include shipping carton.
Pounds
600 1070
1080
1090
1140
600 1070
1080
1090
1140
600 1070
1080
1090
1140
1080
1140
Page 7