Table of Contents
Advertisement
Instruction Book
Page 14
SECTION 3: RECEIVING, HANDLING AND
STORAGE
The entire W-VAC family of circuit breakers is subjected
to complete factory production tests and inspection
before being packed. They are shipped in packages
designed to provide maximum protection to the equip-
ment during shipment and storage, and, at the same
time, to provide convenient handing. Accessories, such
as the maintenance tool and levering crank are shipped
separately.
3-1 RECEIVING
Until the breaker is ready to be delivered to the
switchgear site for installation, DO NOT remove it from
its container. If the breaker is to be placed in storage,
maximum protection can be obtained by keeping it in its
container.
Upon receipt of the equipment, inspect the container for
any signs of damage or rough handing. Open the con-
tainer carefully to avoid any damage to the contents.
Figure 3-1 Typical tools with lifting yoke shown in use
When opening the container, be careful that any loose
items or hardware are not discarded with the packing
material. Check the contents of each package against
the packing list.
Examine the breaker for any signs of shipping damage
such as broken, missing or loose hardware, damaged or
deformed insulation and other components. File claims
immediately with the carrier if damage or loss is detect-
ed and notify the nearest Eaton Sales Office.
Tools and Accessories
Maintenance Tool: Used to charge the closing springs.
(Style 8064A02G01)
Lifting Yoke: Optional item used to lift the breaker.
(Style 8794C67G01 for up to 1250A breakers)
(Style 8794C68G01 for 1600A, 2000A breakers)
(Style 1C95990G01 for 3150A breakers)
Primary Disconnect Plier: Used to install and remove
breaker primary disconnects.
(Style 591C901G02)
IB131009EN
Hide quick links:
Advertisement
Table of Contents
