6.
X-Ref Target - Figure 70
Virtex-6 FPGA Connectivity Kit Getting Started
UG664 (v1.4) July 6, 2011
Getting Started with the Virtex-6 FPGA IBERT Reference Design
Board Setup V – Connect the power connector:
a.
Using the included power supply, connect the power supply connector to the
ML605 board as shown in
b. The power switch SW2 should be switched to the ON position.
Figure 70: Powering Up the ML605 Board
www.xilinx.com
Figure
70.
UG664_47_011710
69