Install Linux Driver - Xilinx Virtex-6 FPGA Getting Started Manual

X-Ref Target - Figure 18
Note:
modifications to the software source code. Running x_v6_trd_setup.exe again causes drivers to
uninstall and clean the install folders.
11. Launch the GUI:
X-Ref Target - Figure 19

Install Linux Driver

12. Configure the desktop PC to boot from the CD ROM:
Virtex-6 FPGA Connectivity Kit Getting Started
UG664 (v1.4) July 6, 2011
Getting Started with the Connectivity Targeted Reference Design Demo
All the drivers required to run the Virtex-6 FPGA Connectivity TRD are successfully
installed. Click Finish to exit the Add Hardware Wizard
Figure 18: All Drivers Installed Successfully
After the drivers are installed, x_v6_trd_setup.exe need not be run until the user makes
a. Double-click on the xpmon icon on the desktop to launch the Performance Monitor
application (Figure 19). Proceed to
The xpmon icon can also be found in the C:\Program Files\Xilinx
Inc\Virtex6 folder.
a. Power the PC system on and watch the initial BIOS screen for a prompt that
indicates which key to use for either:
www.xilinx.com
step 16 to run the application GUI.
Figure 19: Launch GUI
(Figure 18).
UG664_66_060811
UG664_67_063011
27