Table of Contents
Advertisement
Table 56
describes the hardware configuration for the camera interface.
I/O
PG10
PI2
PI3
PH9
PH10
PH11
PH12
PH14
PI4
PI6
PI7
PH8
PI5
PH5
PB11
PB10
1. The default configuration is shown in bold.
UM2854 - Rev 1
Table 56.
Hardware I/O configuration for the camera interface
(1)
Hardware
Setting
PG10 is used as CAMERA PLUG. Detection of the camera daughterboard
ON
presence.
SB103
OFF
PG10 can be used for STMod+.
-
ON
PI2 is used as CAMERA RSTI. Reset of the camera daughterboard.
PI3 is used as CAMERA XSDN. External CLOCK for the camera
-
ON
daughterboard. (Not used inside this camera daughterboard, internal
24 MHz crystal)
-
ON
PH9 is used as DCMI_D0 of the camera daughterboard.
-
ON
PH10 is used as DCMI_D1 of the camera daughterboard.
-
ON
PH11 is used as DCMI_D2 of the camera daughterboard.
-
ON
PH12 is used as DCMI_D3 of the camera daughterboard.
-
ON
PH14 is used as DCMI_D4 of the camera daughterboard.
-
ON
PI4 is used as DCMI_D5 of the camera daughterboard.
-
ON
PI6 is used as DCMI_D6 of the camera daughterboard.
-
ON
PI7 is used as DCMI_D7 of the camera daughterboard.
-
ON
PH8 is used as DCMI_HSYNC of the camera daughterboard.
-
ON
PI5 is used as DCMI_VSYNC of the camera daughterboard.
R145
ON
PH5 is used as DCMI_PIXCLK of the camera daughterboard.
PB11 is used as I2C2_SDA to interface the audio codec, MFX, UCPD,
CTP, the camera, STMod+, and optionally the sensor like the 3D
-
ON
accelerometer and the 3G gyroscope, but also the I
external I
PB10 is used as I2C2_SCL to interface the Audio Codec, MFX, UCPD,
CTP, the camera, STMod+, and optionally the sensor like the 3D
-
ON
accelerometer and the 3G gyroscope, but also the I
external I
Configuration
2
C connector
2
C connector
STM32U575I-EV
Camera
2
C EEPROM and the
2
C EEPROM and the
page 73/105
Advertisement
Table of Contents
Need help?
Do you have a question about the STM32U575I-EV and is the answer not in the manual?