Icmp-X Reset - Barco Freya User Manual

ICMP-X

3.6 ICMP-X reset

ICMP-X reset possibilities
• The Reboot ICMP-X reset button in the GUI of the Web Communicator.
• The ICMP-X reset button in the GUI of the Web Commander.
• The ICMP-X hardware reset button located on the front panel of the ICMP-X (Not recommended, use only
when all other reset possibilities are exhausted!)
How to reset the ICMP-X?
1. click on the Reboot ICMP-X button in the GUI of the Web Communicator (recommended).
or
Click on the ICMP-X reset button in the GUI of the Web Commander.
As a result the projector is safely prepared for the ICMP reboot. All ongoing events on the ICMP-X (e.g.
ingest) are requested to end. After a few seconds the ICMP-X is requested to restart. The READY LED on
the front panel of the ICMP-X starts to blink orange.
Once the READY LED lit continuous green the ICMP-X is up and running.
2. Did the reset of the ICMP-X fail?
► If yes, perform a hardware reset as follows:
1. switch off the light source of the projector.
2. press the ICMP-X hardware reset button a few seconds (reference 3 Image 3–10) .
Warning:
content on the HDDs. A re-configuration of the whole system may be required!
As a result the projector is safely prepared for the ICMP-X reboot. All ongoing events on the ICMP-X (e.g.
ingest) are stopped immediately and the ICMP-X restarts.
Image 3–10
WARNING: Resetting the ICMP-X with the hardware reset button may cause damage to the
content on the HDDs. A re-configuration of the whole system may be required!
42 R5910032 /00 Freya
Resetting the ICMP-X with the hardware reset button may cause damage to the