Table of Contents
Advertisement
iDS-2CD7046G0-AP Network Box Camera Quick Start Guide
6. Adjust zoom and focus. Refer to Section 2.5.
2.3.4 Mounting Type II Housing
Steps
1. Connect and route cables through the cable outlet of the housing.
1) For network, alarm input and output, and audio input and output, plug corresponding plugs to the
rear panel of the camera. See Figure 1-1.
2) For power supply and RS-485, see the following figure.
2. Buckle the housing.
3. Install the housing to surveillance scene.
Using brackets, the housing supports wall mounting, pole mounting, pendent mounting, column mounting,
integrated mounting, and integrated mounting with junction box. The brackets are shown in the figures
below:
QSG iDS-2CD7046G0-AP 022321NA
Figure 16, Fix the Housing to Brackets (2)
Figure 17, Wiring Board in Housing
16
Advertisement
Table of Contents
