Table of Contents
Advertisement
iDS-2CD7046G0-AP Network Box Camera Quick Start Guide
Warnings: Serious injury or death may occur if any of the warnings are neglected.
Cautions: Injury or equipment damage may occur if any of the cautions are neglected.
Warnings Follow these safeguards to prevent
serious injury or death.
Warnings
Proper configuration of all passwords and other security settings is the responsibility of the installer
•
and/or end-user.
In the use of the product, you must be in strict compliance with the electrical safety regulations of the
•
nation and region. Please refer to technical specifications for detailed information.
The power source should meet limited power source or PS2 requirements according to IEC 60950-1 or
•
IEC 62368-1 standard. Refer to the appropriate documentation for detailed information.
Do not connect several devices to one power adapter as adapter overload may cause over-heating or a
•
fire hazard.
Please make sure that the plug is firmly connected to the power socket. When the product is mounted
•
on wall or ceiling, the device shall be firmly fixed.
If smoke, odor, or noise rise from the device, turn off the power at once and unplug the power cable,
•
and then contact the service center.
Cautions
CAUTION: Hot parts! Burned fingers are possible when handling the parts. Wait one-half hour
•
after switching off before handling parts. This sticker indicates that the marked item can be hot and
should not be touched without taking care. For devices with this sticker, device is intended for
installation in a restricted access location, where access can be gained only by service persons or by
users who have been instructed about the reasons for the restrictions applied to the location and
about any precautions that shall be taken.
Make sure the power supply voltage is correct before using the camera.
•
Do not drop the camera or subject it to physical shock.
•
Do not touch sensor modules with fingers. If cleaning is necessary, use clean cloth with a bit of
•
ethanol, and wipe it gently. If the camera will not be used for an extended period, please replace the
lens cap to protect the sensor from dirt.
Do not aim the camera at the sun or extra bright places. Blooming or smearing may occur otherwise
•
(which is not a malfunction), and affect the sensor endurance at the same time.
QSG iDS-2CD7046G0-AP 022321NA
Warnings
Cautions
Cautions Follow these precautions to prevent
potential injury or material damage.
4
Advertisement
Table of Contents
