Draw Area; Set Size Filter - HIKVISION iDS-2CD7 G0 Series User Manual

iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
5. Optional: Repeat the above steps to set more regions.
6. For the arming schedule settings, see Set Arming Schedule. For the linkage method settings, see
Linkage Method Settings.
7. Click Save.
The function is supported only by certain models. The actual display varies by model.

Draw Area

This section introduces the configuration of area.
Steps
1. Click Draw Area.
2. Click on the live view to draw the boundaries of the detection region, and right click to complete
drawing.
3. Click Save.
Click Clear All to clear all pre-defined areas.

Set Size Filter

This part introduces setting the size filter. Only a target whose size is between the minimum value and
maximum value is detected and triggers alarm.
Steps
1. Click Max. Size, and drag the mouse in the live view to draw the maximum target size.
2. Click Min. Size, and drag the mouse in the live view to draw the minimum target size.
3. Click Save.
UM iDS-2CD7xxG0-xxxxx 021021NA
Figure 6-9 Set Rule
52