Alarm, Firmware Version, And Hardware Status Detection - Inspur i24 Server Acceptance Manual

Procedure
Expected result
Description

1.1.6 Alarm, Firmware Version, and Hardware Status Detection

Table 1- 9 Alarm Detection
Item
Objective
Prerequisites
Procedure
1. Power on the system, log in to the web interface through
the management network port, and access the KVM.
During the LSI SAS 3108 startup, press Ctrl+C to enter
controller card setup screen. ( UEFI mode needs to be
viewed in the BIOS)
2. Check the number, location, and capacity of hard disks in
"PD Mgmt",.
3. On the Properties screen, check the Package/FW
Version/BIOS Version
1. Enter the configuration interface of the controller.
2. The Package / FW Version / BIOS Version information of
the controller can be displayed normally.
3. The quantity, location, and capacity of hard disks are the
same as the actual purchase configuration.
None
Content
To verify that the indicator has any alarms.
The structure of the mainboard and hard disk backplane is
proper, and hard disks are detected after the server is powered
on
1. Check the front panel indicator for any abnormalities.
(Please refer to the maintenance manual for details)
2. Check the power module and network port indicators for
Inspur proprietary and confidential information
Copyright © Inspur Electronic Information Industry Co., Ltd.
10