Perform A Monitor Test; Perform A Speaker Test - Polycom G7500 User Manual

Setting
Audio Meter
Reset System
Touch Configuration
Call Statistics

Perform a Monitor Test

To check if you've properly adjusted your monitors, you can perform a color bar test.
Procedure
1. Do one of the following:
▪ In a call:
▪ Out of a call:
2. Select Start.

Perform a Speaker Test

This diagnostic test checks the speaker connections and volume level.
After you start the test at the near site, you hear a tone. If your system is in a call, the far site also hears
the tone.
Procedure
1. Do one of the following:
▪ In a call: Go to Menu
▪ Out of a call: Menu
2. Select Speaker Test.
3. To begin the test, select Start Left, Start Both, or Start Right.
Note that Start Both, which allows you to test both speakers at the same time, might not display.
Polycom, Inc.
> More > Settings > Diagnostics > Color Bars.
> Settings > Diagnostics > Color Bars.
> More > Settings
> Settings
Description
Identifies the left and right audio channels on the
system. Audio meters indicate the audio strength of
your microphones, far-site audio, and any device
connected to the audio ports. To avoid or to fix audio
distortion, configure this setting in the local or web
system interface.
Resets all configurations to factory defaults, and
requires a system restart. You have options to keep
installed certificates, directory entries, system logs, and
call detail reports.
Displays if the system has one or more touch monitors
that require configuration. Touch Configuration opens a
wizard so you can configure your touch displays.
Available in a call only. Displays information to help you
troubleshoot system issues or problems experienced
by call participants.
> Diagnostics > Speaker Test
> Diagnostics > Speaker Test
System Settings
37