Mx410 Data Path Block Diagram; Figure 3-1. Mx410 Data Path Block Diagram - ADTRAN MX410 System Manual

MX410 DATA PATH BLOCK DIAGRAM

As shown in Figure
be mapped between four DS1s (12 DS1s on the MX412), four PPP ports, and a V.35 port. Refer
to "PPP BCP/IPCP Menu"
Any DS0 in DS1 1 can be mapped to any DS0 in DS1 1-4, or any PPP port, or the V.35 port.
Any unmapped DS0 in a DS1 is filled with all ones. Therefore, if an entire T1 is unmapped,
framed all ones are sent.
The default mapping of the 1/0 cross connect is for all the DS1s to be unmapped and trans-
mitting framed all ones. No DS0s are dropped to the PPP or V.35 ports.
DS1 1 DS0 # 1
DS1 1 DS0 # 2
DS1
DS1 1
Framer
DS1 1 DS0 # 24
DS1 2 DS0 # 1
DS1 2 DS0 # 2
DS1
DS1 2
Framer
DS1 2 DS0 # 24
DS1 3 DS0 # 1
DS1 3 DS0 # 2
DS1
DS1 3
Framer
DS1 3 DS0 # 24
DS1 4 DS0 # 1
DS1 4 DS0 # 2
DS1
DS1 4
Framer
DS1 4 DS0 # 24
3-2 PRELIMINARY
3-1, the MX410/MX412 contains a 1/0 cross connect that allows DS0s to
on page 5-32 for more information about using PPP.
1/0 Cross Connect
V.35 Port

Figure 3-1. MX410 Data Path Block Diagram

MX410
PPP 1 DS0 # 1
PPP 1 DS0 # 2
PPP 1 DS0 # 24
PPP 2 DS0 # 1
PPP 2 DS0 # 2
PPP 2 DS0 # 24
PPP 3 DS0 # 1
PPP 3 DS0 # 2
PPP 3 DS0 # 24
PPP 4 DS0 # 1
PPP 4 DS0 # 2
PPP 4 DS0 # 24
TS 1 TS 2 TS 3 TS 4
MX410/MX412 System Manual
PPP 1
PPP 2
PPP 3
PPP 4
MX410 IP
ETH 1 ETH 2 ETH 3 ETH 4
61189500L1-1B