ADTRAN MX410 System Manual page 91

MX410/MX412 System Manual
Option Description
Test
PPP Interfaces
1-4 State
LCP
BCP
IPCP
Ethernet Ports
1-4 Status
Speed
Auxiliary Alarms
1-4 Status
Severity
Power Feed
A/B Status
PSU (MX410 Only)
A/B State
Status
Timing Source
Primary/ Status
Secondary
Source
61189500L1-1B
Table 5-21. Status Screen Fields (Continued)
Function
This field displays one of the following possible states:
• Data Mode: Indicates no tests are active
• Payload Loopback: Indicates that a payload loopback is in progress
• Line Loopback: Indicates that a line loopback is in progress
This field displays the current state of the four PPP interfaces as either
Enabled or Disabled.
This field displays the active state of this control protocol as either Up or
Down.
This field Displays the active state of this control protocol as either Up or
Down.
This field Displays the active state of this control protocol as either Up or
Down.
This field displays the current status as either Up or Down.
This field Displays one of the following speeds as active:
• 10 Mbps, Half Duplex
• 10 Mbps, Full Duplex
• 100 Mbps, Half Duplex
• 100 Mbps, Full Duplex
This field displays the current alarm status as either Active or Cleared.
This field displays the current alarm severity. Severities are defined by the
customer and displayed as Critical, Major, Minor, Alert, or Info.
This field displays the power feed (which connects to the rear of the
MX410/MX412) as either Normal or Failed.
This field displays the current status of the A/B PSUs as either Installed
or Removed.
This field displays the current status of the A/B PSUs as Normal, Failed
(if the PSU is installed), or N/A (if the PSU is not installed).
This field displays the status as either Normal or Failed.
This field Displays internal or DS1 (1-4 on MX410 or 1-12 on MX412).
Menu Descriptions
PRELIMINARY 5-41