Agilent Technologies Infiniium 80000 Series Service Manual page 3

The Agilent Technologies Infiniium Oscilloscope at a Glance
Ease of use with high performance
The Agilent Technologies Infiniium oscilloscopes
combine unprecedented ease-of-use with high-
performance digitizing oscilloscope functionality
to simplify your design and analysis measurement
tasks.
• Traditional oscilloscope front-panel interface
provides direct access to the controls needed
for most troubleshooting tasks.
• Graphical user interface with menus,
windows, dialogs, and toolbars provides easy
access to dozens of configuration and
analysis tools, ensuring you can set up and
make the most complex measurements.
• All models offer 20 GSa/s sampling rate on all
four channels, or 40 GSa/s sampling rate in
two-channel mode.
• Models with bandwidths from 2 GHz to 13 GHz.
Display shows waveforms and graphical user
interface
• Graphical interface allows direct interaction
with waveforms, including drag-and-drop
positioning and instant waveform zoom.
• Touchscreen display allows oscilloscope
operation without an external pointing device.
• Waveforms displayed in color, making
correlation easy.
• Current configuration parameters displayed
near the waveform display and are color-
coded to make identification easy.
• Graphical interface menus and toolbars
simplify complex measurement setups.
Horizontal controls set sweep speed and position
• Main sweep speeds from 5 ps/div to 20 s/div.
• Delayed sweep speeds from 1 ps/div to main
time base setting.
• Intensified waveforms on main sweep
window make it easy to see what will appear
in delayed sweep window.
2
Acquisition and general controls start and stop
the scope and do basic setup
• Run and stop controls for continuous or
single-shot acquisitions.
• Clear display before one or more acquisitions.
• Default setup and Autoscale set initial
configuration.
Hard disk drive and USB 2.0 port for saving and
restoring setups and measurement results
• Store measurement displays for inclusion in
reports and test setup guides.
• Store oscilloscope setups to repeat tests
another time.
• Hard disk stores oscilloscope operating
system.
Trigger setup controls set mode and basic
parameters
• Select Edge, Glitch, or Advanced Modes.
• Choose input source and slope.
• Use graphical user interface to simplify
configuration of pattern, state, delay, and
violation trigger modes.
• Use auxiliary trigger to increase triggering
flexibility.
Vertical controls set attenuation, and position
• Input attenuation adjustable from 1 mV/div to
1 V/div.
• Color-coded knobs make it easy to find the
controls that affect each waveform.
Marker and quick measurements help measure
waveform parameters
• Waveform markers A and B to check voltage
or ∆-time at any point on the displayed
waveform.
• Quick Meas executes up to four predefined
measurements instantly.
Service Policy
The service policy of this instrument requires
replacing defective assemblies. Some
assemblies can be replaced on an exchange
basis.