Agilent Technologies Infiniium 80000 Series Service Manual page 118

To remove the cursor keyboard, remove the two Torx T10 screws that secure the cursor
8
keyboard bracket then lift the cursor keyboard directly out of the front casting.
Figure 6-18
Removing the cursor keyboard
To reassemble the front panel assembly, reverse the above procedure.
9
The cursor keyboard has holes that fit over locating pins in the front panel casting.
C AU T I ON
PREVENT GLASS BREAKAGE!
Use care when handling the touch screen and the flat-panel display to prevent glass breakage.
Inspect the inside surfaces of the touch screen and the flat-panel display closely for dust,
smudges, and fingerprints. Viewing these with line-of-sight 45 degrees to the surface is the best
method for seeing subtle flaws. Clean the surfaces of the touch screen with glass cleaner and
lint-free lens paper before re-assembly. Clean the front of the FPD monitor by applying the glass
cleaner to the lint-free lens paper or soft lens cloth. Do not apply glass cleaner directly to the
FPD monitor.
To remove and replace the keyboard, touch screen, and flat-panel display assemblies
Cursor keyboard
cable
Chapter 6: Replacing Assemblies
Front casting
Cursor keyboard
Cursor keyboard bracket
Aux Out SMB cable
117