Agilent Technologies Infiniium 80000 Series Service Manual page 130

Using a Torx T6 driver, remove the three screws securing the CD-ROM to the support
6
bracket.
When re-assembling, torque the three Torx T6 screws to 1.5 in-lb.
Using a Torx T10 driver, remove the two screws securing the CD-ROM adapter board
7
to the support bracket.
When re-assembling, torque the two Torx T6 screws to 1.5 in-lb.
Figure 6-27
Torx
T6
Removing the support bracket and adapter board
To replace the CD-ROM drive, reverse the above procedure.
8
CD-ROM
drive
Chapter 6: Replacing Assemblies
To remove and replace the CD-ROM drive
Support
bracket
Torx
T6
Torx
T6
Adapter
board
Torx
10
129