Table of Contents
Advertisement
Chapter 2: Setting Up the Oscilloscope
To connect optional InfiniiMax oscilloscope probes
To disconnect the probe, push the small latch on top of the probe connector to the left,
3
then pull the connector body away from the front panel of the oscilloscope without
twisting it.
Figure 2-9
Disconnecting the Oscilloscope Probe
C AU T I ON
Do not attempt to twist the snap-on probes on or off the oscilloscope's BNC connector. Twisting
the probe connector body will damage it.
C AU T I ON
For the 8000 series oscilloscopes do not exceed the maximum input voltage rating. The maximum
!
input voltage for 50 Ω inputs is 5 Vrms, CAT I. Maximum voltage at 1 MΩ impedance is ±100 V
(DC + AC) [AC < 10 kHz], CAT I.
26
Hide quick links:
Advertisement
Table of Contents
