Agilent Technologies Infiniium 80000 Series Service Manual page 128

Figure 6-25
T20
screws
Removing the hard disk drive
To replace the hard disk drive, reverse the above procedure.
6
Be sure to reconnect the hard drive ground cable to the upper-right shock mount screw.
C AU T I ON
DO NOT OVER TIGHTEN THE SCREWS!
Do not overtighten the Torx T10 screws that secure the Hard Disk Drive to the bracket. Torque
to 3 in-lb.
Hard disk drive
Shock
mount
plate
Chapter 6: Replacing Assemblies
To remove and replace the hard disk drive
T10 screw
127