Troubleshooting - Globe GVP6 Instruction Manual

ISSUE
Vacuum packaging machine
does not start.
Vacuum packaging machine
stops unexpectedly while it is
running.
Vacuum sealing bag is not
sealed or is not sealed
correctly at lid opening.
Vacuum packaging machine
does not maintain the
optimum vacuum.
Air leaking from lid.
Vacuum sealing bag starts to
swell during vacuum cycle.
Lid does not lift properly.
If problem continues and the above solution does not remedy the issue, please call Globe's Service Department
at 866-260-0522.

Troubleshooting

CAUSE
Vacuum is unplugged.
Check that the rear microswitch is
correctly energized.
One or more of the two cables have
disconnected from the sealing bar.
Sealing bar too close to the gasket of
the lid.
Sealing time not suitable for the vacuum
sealing bag thickness.
Vacuum sealing bag is wet or creased.
Silicone bar on lid is damaged.
Oil is old.
Cleaning pump
Vane pump
Seal on lid needs cleaned or replaced.
Seal on lid needs cleaned or replaced.
Vacuum sealing bag not in correct
position.
Sealing bar not in correct position in
vacuum chamber.
Pistons are not properly placed inside of
vacuum packaging machine.
SOLUTION
Plug in vacuum packaging. Turn on
the ON/OFF switch to start. Light will
illuminate.
Make sure microswitch under the left
hinge is correctly energized when the lid
is lowered.
Make sure the 2 cables are fixed to the
sealing bar.
Make sure distance from the sealing bar
and the lid is 4-5 mm
Adjust the seal time for the vacuum
sealing bag thickness.
Make sure the vacuum sealing bag is not
wet or that there are no creases.
Clean or replace the silicone bar on the
lid.
Change the oil.
Call for service.
Call for service.
Clean or replace the seal on the lid.
Clean or replace the seal on the lid.
Stop the vacuum packaging machine
and reposition the vacuum sealing bag
on the sealing bar.
Make sure distance from the sealing bar
and the lid is 4-5 mm.
Call for service to adjust pistons.
Page 17