Table of Contents
Advertisement
•
ALWAYS use equipment in a work area with sufficient light and space.
•
NEVER bypass, alter or modify this equipment in any way from its original condition. Doing so can create
hazards and will void the warranty.
•
NEVER operate vacuum packaging machine without all warnings attached.
UNPACKING:
1. Inspect the package carefully before unpacking. Note any damage on the delivery paperwork and take
pictures.
2. Unpack the vacuum packaging machine immediately after receipt. If the machine is found to be damaged,
save the packaging material and take pictures of damage. Contact Globe Food Equipment as soon as
possible. Contact information and further details can be found at https://globefoodequip.com/support/order-
return-policy.html
3. You should receive the vacuum packaging machine, two filler plates, pump oil, Allen wrench and an
instruction manual. Contact the factory or your local supplier if you did not receive all of these materials.
4. Read this manual thoroughly before operation. DO NOT continue with use of the vacuum packaging machine
if you have any questions or do not understand everything in the manual. Contact your local representative
or the factory first.
5. Remove vacuum packaging machine from the corrugated box.
6. Make sure warning labels are correctly positioned, legible, and instruction manual is available near vacuum
packaging machine.
7. Screw legs into the permanently fastened nuts on the four corners of the unit and tighten by hand. Legs must
be installed to adequately provide proper cleaning under the unit.
8. Level unit by adjusting the four feet and tighten securely. The feet have an adjustment of one inch to line up
with other Globe countertop products. Do not slide unit with legs installed: use two people to lift if necessary
to move unit.
9. Release the lid lock located on the right side of the vacuum packaging machine and allow the lid to lift and
remain open.
Note: To extend the life of the lid hinges, leave the lid open when vacuum packaging machine is not
in use.
10. Install oil provided with the vacuum packaging machine in the motor/pump.
a. Locate the access panel on the back of the vacuum packaging machine.
b. Unscrew four screws that attach the access panel to the back of the vacuum packaging machine.
c. Use the provided Allen wrench to remove the nut above the sight glass.
d. Install the oil in the motor/pump.
Note:
Make sure oil level is halfway between the MIN and MAX indicator lines on the motor/
pump.
Page 8
Unpacking & Installation
TO AVOID SERIOUS PERSONAL INJURY, USE
VACUUM PACKAGING MACHINE IN A SUFFICIENT WORK AREA
Advertisement
Table of Contents
