Power smart DB2801 Instruction Manual page 5

WARNING! Turn off the power switch and disconnect the battery before making any adjustments,
inspecting, servicing, changing accessories, cleaning the snow thrower,or when any other dangerous
conditions present. Any such operation should be performed after revolving parts inside the snow
thrower stop completely. Such preventive safety measures reduce the risk of starting the power tool
accidentally.
WARNING! When replacing any parts, you must strictly observe the instructions and procedures
described in this user manual. Special care should be paid to any rubber parts, since these parts may
increase the motor load and decrease its mechanical power if damaged.
WARNING! If you notice that the snow thrower is not running properly or hear abnormal sounds
from the motor when it is in use, immediately stop the machine, disconnect the battery, and contact
customer service center.
• Surfaces – This snow thrower is intended for use on paved surfaces. Do not use on gravel, stone or
other unpaved surfaces unless the snow thrower is adjusted for such surfaces according to the
instructions given in the operator's manual.
• Moving parts present risks – Keep your face, hair, clothing, hands, and feet away from moving
parts. All guards and safety attachments must be installed properly before using the unit. Shut off
and disconnect the battery before touching any parts other than the handles and switch.
• Avoid unintentional starting – Make sure the safety switch and the switch bar lever are in the off
position before inserting the battery in the unit. Do not carry the snow thrower with the safety
switch and the switch bar lever engaged.
• Do not overreach – Maintain proper footing and balance
at all times. Place heels firmly on the ground and tightly grasp the handle bar. Watch for uneven
surfaces and do not overreach. In case you fall or collide with the snow thrower, inspect the unit for
any damages or cracks. When stepping backwards, be careful to avoid obstacles beneath your feet or
behind you to avoid falling.
WARNING! If the snow thrower strikes any object,follow these steps:
1. Stop the snow thrower. Remove the battery.
2. Inspect for damage.
3. Repair any damage before restarting and operating the snow thrower.
Battery + Charger Safety Instructions
IMPORTANT! Analyses confirm that incorrect use and poor care of high-performance batteries are
the main factors responsible for personal and/or product damage.
WARNING! Use only approved replacement batteries; other batteries may damage the cordless
snow thrower and cause it to malfunction, which can lead to serious personal injury.
CAUTION! To reduce the risk of injury, charge the DB2108 lithium-ion battery pack only in its
designated lithium-ion charger, the DB2208. Other types of chargers present risk of fire, personal
injury and damage. Do not wire a battery pack to a power supply plug or car cigarette lighter.Such
misuse will permanently disable or damage the battery pack.
• Avoid dangerous environments – Do not charge the battery pack in rain, snow or in damp or wet
locations.Do not use the battery pack or charger in the presence of explosive atmospheres
(gaseous fumes, dust or flammable materials) because sparks may be generated when inserting or
removing the battery pack, which could lead to a fire.
• Charge in a well-ventilated area – Do not block the charger vents. Keep them clear to allow for
proper ventilation. Do not allow smoking or open flames near a charging battery pack. Vented
gases may explode.
NOTE: The safe temperature range for the battery is -4°F (-20°C) to 113°F (45°C). Do not charge the
5