Preliminary Cleaning; Duct Sheets And Shelf Installation - VWR VWR51014991 Operating Instructions Manual

Section 1
Installation and Start-Up
Stacking Incubators
(continued)

Preliminary Cleaning

Duct Sheet and Shelf
Installation
1-6 Air Jacketed CO2 Incubator
7. Thread one 1/4 x 20 bolt and washer
included with the stacking brackets,
into the hole behind the cover plate.
Do not tighten. Refer to Figure 1-9.
8. Remove the cover plate from the same
area on the other side of the top unit.
9. Thread the other 1/4 x 20 bolt and washer into this hole.
10. Tighten the bolts on both sides.
11. Assemble the door hinges to the unit. Secure with the screws.
12. Plug the door cord into the connector, as previously. Secure the cover
plate.
13. Install the cover plate on the other side of the unit. The stacked
incubators are ready for service.
1. Remove vinyl from shelf channels, duct sheets, and air duct, if present.
2. Using a suitable laboratory disinfectant, clean all interior surfaces.
Caution Before using any cleaning or decontamination method except
those recommended by the manufacturer, users should check with the
manufacturer that the proposed method will not damage the equipment.
Accidental spills of hazardous materials on or inside this unit are the
responsibility of the user.
1. Installed included grommets into the back
flange of each duct sheet; 6 grommets per sheet.
See Figure 1-10.
2. Install the side ducts with the tabs facing into
the center of the chamber with their slots up.
There are no right side or left side ducts, simply
rotate one of them to fit the opposite side. Tilt
the side ducts as they are placed into the
chamber so the tops fit into the top air duct,
then guide them into the vertical position.
Figure 1-11 shows the side duct as it would be
oriented for the right side of the chamber.
Figure 1-9. Bolt Hole
s
Cover plate and bolt hole
with door connector
Figure 1-10. Grommets
on back of duct sheet
VWR International