Installation; Operation - Gabarron IDM-2000 Installation Instructions And User Manual

 Do not touch the fireguard or reflecting cover when the heater is in use; do not insert any objects into the
fireguard to prevent high temperature scalding.
 The heater is provided with an anti-tilt switch will switch off the heater if it is overturned, and will switch it on
again automatically when it is restored to its upright position.
 The infrared heater is designed to only work in a horizontal position. Never operate your appliance if it has
fallen over.
 This movable appliance is designed for use indoor and outdoor. Although the heater may be used outdoors,
the main plug must only be connected to the supply indoors.
 Do not use the heater while sleeping. Never leave the heater unattended while it is operated.
 Do not let the cable hang over the edge of a table or counter or let it come into contact with any hot surfaces.
 Do not use extension cable. This could overheat and cause fires.
 Never touch the heater with wet or humid hands or barefoot.
 The heater must be disconnected during installation and cleaning.
 Never rotate the heating part of the appliance during operation. To change the tit angle of the heating part, we
advise you to wait for 15 minutes after the appliance has been switched off.
 Never dismantle the components of the heater or replace the components with the ones that do not meet
the safety requirements.
WARNING: The surface of this heater can be hot.
CAUTION: Some parts of this product can become very hot and cause burns. Particular
attention must be given when children and vulnerable people are present.
WARNING: IN ORDER TO AVOID OVERHEATING, DO NOT COVER THE
HEATER.

2.- INSTALLATION

Open the box to take out the heater and all the accessories.
Make the four holes on the wall in accordance with the four holes at the back of
the heater.
Insert wall plugs and tighten the screws.
The heater must be positioned at least 1.8 m from the floor, and a minimum
distance of 30 cm from the ceiling.
Between the plan and the head of the screw you must leave enough space in a way
to hook the heater.
Attach the heater to the four screws and slide down.
According to the request of use angle, Heating Element Assembly can adjust angle at 0º~45º.

3.- OPERATION

WARNING : Always choose a safe location for the heater, keeping in mind the safety instructions outlined in
point 1.
The appliance is switched on by means of the pull switch. The slight vibration noticeable when the appliance is
switched on will stop after a few seconds.
The indicator on the heater will show different positions in a rotary way:
- Position 0: Stop
- Position 1: 650 W (normal power)
3