Table of Contents
Advertisement
Installation
Pressure Sensor
1. Position the pressure sensor so it is hanging
downwards on the cable (F
2. Make sure that the inlet openings on the protective
cap are not clogged (F
F
. 4
IG
3. Insert the pressure sensor through the 1 in. npt
hole.
4. Position and screw a 1/2 in. to 1 in. adapter into the
1 in. npt hole.
5. Tighten the 1/2 in. cord grip to 1.3 ft-lbs (1.8 N•m)
to set the pressure sensor position. A fixed sensor
position is required to prevent measurement errors.
6. Position the sensor at least 2 in. (50 mm) from the
bottom of the tank to avoid sediment or other
contaminants that may interfere over time with the
device taking accurate measurements.
6
. 5).
IG
. 4).
IG
Protective Cap
F
. 5
IG
3A8622B
Advertisement
Table of Contents
