Placing A Call; Press '1' To Connect; Optional Configuration - MCK EXTender 4000 Quick Installation Manual

Placing a Call

Once the EXTender 4000 is installed and powered-up, the remote telephones can go on-line. Follow the
procedure below to place a call.
Procedure
At the remote location, the telephones should display the following message if Autoconnect is disabled:

Press '1' to connect

Press 1 on the keypad to connect the telephone to the corporate PBX/KSU
Place a test call and check for clear reception.
Note: If the connection is "noisy" or nonexistent, refer to the PBXgateway System Administrator's Guide
for troubleshooting steps.

Optional Configuration

The EXTender 4000 MI has optional configuration parameters that provide the following capabilities:
Auto-Connect – This is a Remote module option, which automatically connects remote users (tele-
phones) when the EXTender 4000 is rebooted or brought on-line. (Eliminates the need to press "1" on the
remote telephone.) Enable this feature for non-display telephones since you cannot see the "Press '1' to
Connect" message.
Admin Password – If configured, this option restricts access to the EXTender 4000 MI, by requiring a
password for entry. You must enter the Admin Password before you can change any configuration
parameters.
Note: The EXTender 4000 units and the PBXgateway units have their own separate Admin passwords.
Password – This option provides a secure link between the PBXgateway and the EXTender 4000. If this
option is configured, a password is assigned to both the EXTender 4000 and the PBXgateway. This
password is necessary to connect to the PBXgateway. The password on the EXTender 4000 must match
the password assigned to the port on the PBXgateway.
Note: Refer to the PBXgateway System Administrator's Guide for more information on configuring these
options.
EXTender 4000 Universal Quick Installation Guide 23