Raider RD-SGC04 User Manual page 20

etc.
9. Point the gun at the target object.
10. Push the ON / OFF switch on the machine.
WARNING! Danger of injury! Never pull the trigger guard while adjusting the air cap.
3. SPRAY TECHNIQUE
● The spray result depends heavily on the smoothness and cleanliness of the surface to be sprayed.
Therefore the surface should be carefully prepared and kept free of dust.
● Cover all surfaces not to be sprayed.
● Cover screw threads or similar parts of the target object.
● It is advisable to test the spray gun on cardboard or a similar surface to find the correct setting. Important:
Begin spraying outside of the target area and avoid interruptions inside the target area.
● Correct (Fig. 1 a) Be sure to hold the spray gun at an even distance of approx. 2.5- 30 cm to the target
object.
● Incorrect (Fig. 1 b) • Heavy spray fog build-up, uneven surface quality.
● An even movement of the spray gun results in an even surface quality.
● When coating material builds up on the nozzle (A) and air cap (B) (Fig.2), clean both parts with a solvent or
water.
a
b
Fig 1
Interruption of Work
● Turn the machine off.
● Put the spray gun in the spray gun holder.
Taking Out of Operation and Cleaning
1. Turn the machine off. Activate the trigger guard so that the coating material in the spray gun flows back
into the container.
material tin.
2. Unscrew the container. Empty any remaining coating material back into the
3. Pre-clean the container and feed tube with a brush.
4. Pour solvent or water into the container. Screw the container back on.
Use only solvents with a flashpoint over 21°C
5. Turn on the machine and spray the solvent or water into a container or a cloth.
6. Repeat the above procedure until the solvent or water emerging from the nozzle is clear.
7. Turn the machine off.
8. Then empty the container completely. Always keep the container seal free of coating material residue and
check for damage.
9. Clean the outside of the spray gun and container with a cloth soaked in solvent or water.
10. Unscrew the union nut and remove the air cap and nozzle. Clean the air cap and nozzle with a brush and