Micromeritics MicroStar 022 Installation Manual page 20

Configuration
6. Click Apply
7. Close the Quadera program.
TAMS
You may receive an error message the first time you start the TAMS software. This is
because the MicroStar is not configured with TAMS. Click Continue; you should not
see this message after configuration is complete.
1. Start the TAMS program; the OP IP Addresses.vi dialog is displayed.
2. Click Add
3. Complete the fields as follows:
Type
IP Address
Name
4. Click OK
you added is now displayed in the dialog.
5. Highlight the device you added and click
14
, then Close to close the dialog.
; the IP Config.vi dialog is displayed.
220
192.168.77.220
User-specified
to save the information and return to the OP IP Addresses.vi dialog; the type
; the dialog will close automatically.
Connect
MicroStar 022
Jul 09