Positioning And Connecting The Set; Safety Instructions - Loewe CT1163 Operating Instructions Manual

Positioning and Connecting the Set

5 cm
5 cm
ARIAL
RF–OUT
Positioning
Position your set so that no bright light or
sunlight falls directly onto the screen.
Otherwise the brilliance of the picture will
be affected by reflections.
The air vents on the back of the set
must be kept clear at all times to allow the
set to cool. Leave enough room at the back
if you stand your set on a shelf or in a
5 cm
cabinet.
Connecting
To the mains
Plug the TV's mains plug into a socket. The
set will operate on 195 to 260 volts AC, 50
or 60 hertz.
To the antenna
Connect your set to the antenna as shown
opposite with a coaxial antenna cable (75
ohms).
Connecting a video recorder
Connect the coaxial antenna cable to the
antenna socket (aerial) of the recorder.
Connect the output of the video recorder
(RF-Out) to the TV's antenna input (VHF/
UHF) with a second antenna cable.

Safety Instructions

• If the set is moved from a cool
environment to a warm room, do not
switch it on until it has been given
reasonable time (about 1 hour) to warm
up.
• The set is designed for the home and
office and may not be used in rooms
with a high humidity or concentration of
dust.
• Make sure the set stands firmly when
placed on a shelf, a table or in a cabinet.
• Position the set so that it is not exposed
to direct sunlight and additional heat
from radiators.
• The slits in the rear panel are for cooling
of the set and should never be covered
up with mats or curtains.
• Make sure no metal parts, pins, paper
clips, liquids or wax are dropped or spilt
through the ventilation slits in the back of
the set. If this should happen, switch off
the the set immediately with the On/Off
switch and pull out the mains plug.
• Never remove the rear panel from the
set. Only have the set repaired by the
service technician.
• In case of imminent thunderstorms, pull
out the mains plug and the antenna plug
from the socket to protect your set.
7