Table of Contents
Advertisement
For the steps below, the L.E.D. located inside the interface can only be seen while active. The
interface does not need to be opened to see the L.E.D.
Turn on the vehicle.
1.
2.
Connect the AX-HYKIA1-SWC harness to the wiring harness in the vehicle.
Green & Red LED
3.
The L.E.D. will initially turn solid Green, then turn off for several seconds,
while it auto detects the radio installed.
Green LED
4.
The L.E.D. will then flash Red up to (21) times, indicating which radio is
connected to the interface, and then turn off for several seconds. The L.E.D.
will then turn solid Red, while the interface auto detects the vehicle.
Green & Red LED
Green or Red LED
6
PROGRAMMING
5.
Green & Red LED
Green LED
6.
7.
The radio will shut off at this point. This process should take 5 to 30
seconds. Once the vehicle has been auto detected by the interface, the
L.E.D. will turn solid Green, and the radio will come back on, indicating
programming was successful.
Turn the vehicle off then on again to make sure the programming worked.
Test all functions of the installation for proper operation, before
reassembling the dash.
Advertisement
Table of Contents
