Table of Contents
Advertisement
For the steps below, the L.E.D. located inside the interface can only be seen while active. The
interface does not need to be opened to see the L.E.D.
• Start the vehicle.
• Connect the AXDIS-GMLN30 harness to the wiring harness in the vehicle.
• The L.E.D. will initially turn on solid Green, then turn off for a few seconds while it auto
detects the radio installed.
• The L.E.D. will then flash Red up to (18) times indicating which radio is connected to the interface,
and then turn off for a couple of seconds. Pay close attention to how many Red flashes there
are. This will help in troubleshooting, if need be. Refer to the L.E.D. feedback section for more
information.
• After a couple seconds the L.E.D. will turn on solid Red while the interface auto detects
the vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.
• Once the vehicle has been auto detected by the interface, the L.E.D. will turn on solid
Green, and the radio will come back on, indicating programming was successful.
• Test all functions of the installation for proper operation, before reassembling the dash. If
the interface fails to function, refer to Resetting the AXDIS-GMLN30.
Note: The L.E.D. will turn on solid Green for a moment, and then turn off under normal
operation after the key has been cycled.
4
PROGRAMMING THE AXDIS-GMLN30
Advertisement
Table of Contents
