Axxess AX-GMCL2-SWC Installation Instructions Manual
  1. Manuals
  2. Brands
  3. Axxess Manuals
  4. Automobile Accessories
  5. AX-GMCL2-SWC
  6. Installation instructions manual

Axxess AX-GMCL2-SWC Installation Instructions Manual

Gm data interface with swc 2000-2013
Hide thumbs Also See for AX-GMCL2-SWC:
Table of Contents

Advertisement

Quick Links

GM Data Interface with SWC
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake,
reverse, and speed sense)
• Retains chimes
• Retains audio controls on the steering wheel
• Retains OnStar / OE Bluetooth
• Adjustable OnStar level
* The RSE must be activated by the factory radio
• AX-GMCL2-SWC interface • AX-GMCL2-SWC harness
• 16-pin harness with stripped leads
• 4-pin harness with stripped leads
• Female 3.5mm connector with stripped leads
Axxess Integrate
®
Installation instructions for part AX-GMCL2-SWC
AX-GMCL2-SWC
2000-2013
INTERFACE FEATURES
• Retains the factory AUX-IN jack
• Retains RSE (rear seat entertainment) *
• Retains SAT (satellite radio)
• Can be used in non-amplified, or analog/
digital amplified models
• Retains balance and fade (excludes digital
amplified models)
• Micro "B" USB updatable
INTERFACE COMPONENTS
APPLICATIONS
See application list inside cover
®

Table of Contents

Connections to be made ................................................3-6
For models without an amplifier .................................. 3
For models with an analog amplifier ........................... 4
For models with a digital amplifier .............................. 5
Installing the AX-GMCL2-SWC ......................................... 6
Adjusting the AX-GMCL2-SWC ......................................... 8
Extra features ................................................................8-9
Steering wheel control extra settings.........................9-12
L.E.D. feedback ............................................................. 9
Changing radio type ................................................... 10
Resetting the AX-GMCL2-SWC ................................... 12
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
• Small flat-blade screwdriver
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
© COPYRIGHT 2016 METRA ELECTRONICS CORPORATION

Advertisement

Table of Contents
loading

Related Manuals for Axxess AX-GMCL2-SWC

Summary of Contents for Axxess AX-GMCL2-SWC

  • Page 1: Table Of Contents

    Installing the AX-GMCL2-SWC ......... 6 • Provides accessory power (12-volt 10-amp) • Retains the factory AUX-IN jack Initializing & programming the AX-GMCL2-SWC ..6-7 • Retains R.A.P. (retained accessory power) • Retains RSE (rear seat entertainment) * Adjusting the AX-GMCL2-SWC ......... 8 •...
  • Page 2 ® AX-GMCL2-SWC Applications BUICK CHEVROLET (CONT) OLDSMOBILE Century 2004-2005 Express 2003-2007 Canyon 2004-2012 Alero 2001-2004 Impala 2000-2005 LaCrosse 2005-2009 Envoy * 2002-2004 Bravada * 2002-2004 Rainier * 2004 Kodiak C4500-C8500 2003-2009 Envoy 2005-2009 Intrigue 2002 Malibu 2001-2003 Rainier 2005-2007 Savana...

  • Page 3: Connections To Be Made

    Attention! This interface will work with models that are either non-amplified, analog From the AX-GMCL2-SWC harness to the aftermarket radio: amplified, or digital amplified. Please follow the instructions carefully for your model • Connect the Black wire to the ground wire.

  • Page 4: For Models With An Analog Amplifier

    Green, Green/Black, Purple, Purple/Black From the 16-pin harness with stripped leads to the aftermarket radio: From the AX-GMCL2-SWC harness to the aftermarket radio: • Connect the Red wire to the accessory wire. • Connect the Black wire to the ground wire.

  • Page 5: For Models With A Digital Amplifier

    • Connect the Light Green wire to the parking brake wire For models with a digital amplifier: From the AX-GMCL2-SWC harness to the aftermarket radio: From the 16-pin harness with stripped leads to the aftermarket radio: • Connect the Red wire to the accessory wire.

  • Page 6: Mm Jack Steering Wheel Control Retention

    For the radios listed below, connect the included female 3.5mm connector with stripped leads onto the male 3.5mm SWC jack of the AX-GMCL2-SWC. Any remaining wires, tape off and disregard : • Connect the AX-GMCL2-SWC harness to the wiring harness in the vehicle.
  • Page 7 ® AX-GMCL2-SWC Initializing and programming the AX-GMCL2-SWC (Cont) For the steps below, the Red L.E.D. (located inside the interface, next to the 7. Press all the buttons to ensure that they are working as intended. potentiometer) can only be seen while active. The interface does not need to be 8.

  • Page 8: Adjusting The Ax-Gmcl2-Swc

    • If your vehicle comes equipped with AUX-IN, rear seat entertainment, or • With the vehicle and radio turned on, turn the volume up 3/4 of the way. satellite radio, the AX-GMCL2-SWC can retain these features. • With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise •...

  • Page 9: Steering Wheel Control Extra Settings

    Each time the SOURCE button is pressed for 2 seconds the source * Note: If the AX-GMCL2-SWC flashes Red (7) times, and you do not have an Alpine radio will change. The sequence of sources are SAT/RSE/AUX-IN. The AX-LCD will connected to it, that means the AX-GMCL2-SWC does not detect a radio connected it.

  • Page 10: Changing Radio Type

    Mute. Follow the steps below to remap the steering wheel control buttons programmed. 1) Ensure the AX-GMCL2-SWC is visible so you can see the L.E.D. flashes to 4) Press and hold the Volume-Up button until the L.E.D. goes solid, and then confirm button recognition.

  • Page 11: Dual Assignment Instructions (Long Button Press)

    Volume-Up button for (1) second until the L.E.D. comes on, and then release The AX-GMCL2-SWC has the capability to assign (2) functions to a single the Volume-Up button. This will tell the AX-GMCL2-SWC that this function is not button, except Volume-Up and Volume-Down. Follow the steps below to available and it will move on to the next function.

  • Page 12: Resetting The Ax-Gmcl2-Swc

    ® Installation instructions for part AX-GMCL2-SWC Steering wheel control extra settings (Cont) IMPORTANT Dual assignment legend If you are having difficulties with the 1. Not allowed 6. ATT/Mute 11. Play/Enter 16. Fan-Down * installation of this product, please call our 2.

Table of Contents