sauter TC 1250-0.1F Instruction Manual page 4

Resolution
Measurement
uncertainty
off-set accuracy
PC connection
Power supply
Ambient
temperature
Air humidity
Dimensions
Weight
Scope of delivery
Attention: All accuracy specifications apply after adjustment!
4
0,1 µm (0 to 99,9 µm), 1 µm (over 100)
3 % of the measured value or Min ± 2,5 µm.
Applies within the tolerance band of ± 100 µm
around the typical measuring range if a two-point
calibration was also performed within this
tolerance band
1 % of the measured value or min. 1,0 μm
Applies within ± 50 μm around the offset Accur
RS-232 interface
4x1.5 AAA batteries (UM-4)
126 x 65 x 27mm
Ca 81g (without batteries)
Carrying case, operating instructions
Depending on the type:
1. built-in measuring probe F: TC 1250-0.1 F, with
F/N key
2. built-in measuring probe N: TC 1250-0.1 N, with
F/N key
3. built-in measuring probe FN: TC 1250-0.1 FN,
without F/N u.S/C key
- Spacer foils, for each model
- Zero plate (aluminium) for model N
- Zero plate (iron) for model F
- 2 zero plates (aluminium and iron) for model FN
(combination unit)
Optional accessories: Software and cable RS-
232C: ATC-01
Point
0°C to 50°C
≤
80%
TC-BA-e-2020