Table of Contents
Advertisement
Reference Information, cont'd
Button Labels
Figure A-1 provides blank button labels for 16-button switchers. Figure A-2 on
page A-11 provide blanks for 32-button switchers. Feel free to photocopy them
or cut them out of the manual, write button information in each button area as
desired, and put them in the switcher's label window.
To remove a panel, insert the Phillips-head end of a Tweeker or small Phillips-head
screwdriver into the hole in one end of the panel, and gently slide the tab at the
edge of the panel out of the recess in the switcher housing.
Printing Instructions
If you print these strips to cut out and use in your switcher:
•
•
•
A-8
MTPX Twisted Pair Matrix Switchers • Reference Information
Print on 8-1/2" by 11" (letter) paper, in portrait orientation.
Set page scaling to None.
After printing, verify that the printed strips fit behind the panel. Your
printer configuration may cause the strip to be printed smaller or larger than
specified.
Advertisement
Table of Contents
