Table of Contents
Advertisement
Button Labels
Use either blank 8-button strips in figure
"Remote
Installing Labels in the Switcher Buttons
Install new labels in the switcher front panel buttons as follows:
1.
2.
3.
4.
5.
6.
7.
8.
Other Fiber Optic Models
FOX DA8 SM
FOX DA8 MM
FOX 500 DA6 SM
FOX 500 DA6 MM
Control").
Make new labels and cut them out.
NOTE:
For best results, print or copy on transparent or translucent material.
Remove the button from the switcher; use a small, flat bladed screwdriver such as an
Extron Tweeker to gently pry a button out from the front panel (see figure 18).
Clear Lens
Pry the two
pieces apart.
Separate the two-
piece button here at
the corner.
Figure 18.
Illuminated Button Label Replacement
Locate the notch in the corner of one side of the clear button cap lens.
Separate the white backing (diffuser) from the clear button cap (lens); insert the blade of
the small screwdriver into the corner notch and gently twist the blade.
Save the translucent, white diffuser, but remove the text/label insert from the
transparent button cap lens.
Insert the replacement button label into the button cap. Check for correct label
orientation.
Align the white diffuser plate with the cap (lens). The bumps on the diffuser plate
should be aligned (top and bottom) with the notches on the clear button cap. Firmly
snap it into place.
Align the tabs on the switcher plunger with the notches on the diffuser plate. Gently,
but firmly, press the reassembled button into place in the front panel of the switcher.
Part Number
60-927-02
60-927-01
60-863-02
60-863-01
19
or the Button-Label Generator software (see
Base
T E
X T
Diffuser
Button Label
Extron FOX SW8 • Reference Information
23
Advertisement
Table of Contents
