System Configuration - Avaya Communication Server 1000M Single Group Manual

3. Repeat step 2 for the remaining MDF cables from J2 through J10 for card slot 1
4. Replace the locking bar(s) in the cabinet(s) over the cable connectors.
Power supply for MCR
The cabinet can be powered with an AC power system using the NTAK04 AC/DC power supply.
It can also be powered with a DC power system using the NTAK05 DC power supply from a –
52 V battery source through the NTAK28AA Junction box and the NTAK0410 power cable.
Before you install the power supply into the cabinet, set switches SW1 through SW4.
18: NTAK04 AC/DC and NTAK05 DC power supply switch settings
appropriate switch settings.
Table 18: NTAK04 AC/DC and NTAK05 DC power supply switch settings
Message Waiting; -150 V
Message Waiting; -120 V
Ringing; 86 Vrms
Ringing; 80 Vrms
Ringing; 75 Vrms
Ringing; 70 Vrms
Note:
Ringing frequency selection is made with a three-way switch located to the left of the 4-
position DIP switch at the top of the power supply. The typical North American setting is -150
V, 86 Vrms, and 20 Hz.

System configuration

The configuration and administration of the MCR at the local site are identical to the standard
system configuration and administration and do not require special considerations.
However, there are some initial setup functions that must be considered at the local and the
remote sites. These functions are administered over the MMI port connected to a terminal or
a TTY at the local or remote site.
Mini-Carrier Remote Fundamentals
through 9.
Voltage SW1 SW2
ON
OFF
OFF
ON
OFF
OFF
System configuration
on page 69 lists the
SW3 SW4
OFF OFF
OFF OFF
ON OFF
OFF ON
March 2013
Table
69