Quick Reference To System Installation - Avaya Communication Server 1000M Single Group Manual

Installation and configuration
Adding one or more MCR sites to a system is treated as a straightforward system expansion;
that is, the system should be fully operational before the MCR equipment is installed and
connected to the system. This simplifies installation and fault isolation during installation.
General preinstallation and installation procedures are listed below.
Preinstallation procedures at both the local and remote sites include:
• ordering T1 service from your telephone company,
• preparing the site,
• unpacking and inspecting the equipment, and
• taking inventory of the MCR and system equipment.
Local site installation procedures include:
• selecting line card slots for the Local Mini-carrier Interface card (LMI) and the Local Mini-
carrier Extender card(s) [LMX(s)],
• installing the LMI and LMX(s) into the selected line card slots,
• connecting the host SDI and the MMI terminal cables to the LMI Multi I/O cable
assembly,
• connecting the LMI/LMX Multi-I/O cable assembly, and
• connecting the T1 carrier link(s) to the LMI Multi-I/O cable assembly.
Remote site installation procedures include:
• installing the cabinet, if not currently installed,
• installing the Remote Mini-carrier Interface card (RMI) into the cabinet controller card
slot,
• installing the RMI Multi I/O cable assembly at the connector immediately below the RMI,
and
• connecting the MMI terminal and T1 carrier link(s) to the RMI Multi I/O cable assembly.

Quick reference to system installation

Basic familiarity with system operation and general system installation practices is required for
MCR installation.
52 Mini-Carrier Remote Fundamentals
Comments? infodev@avaya.com
March 2013