GE TruTrak+ 3900 User Manual page 42

3900/3900P User's Manual
ALL MUTE
Use this option to enable (YES) or disable (NO) the ability to mute audible alarms.
•
•
BAUD RATE
Use this option to select the appropriate baud rate when sending serial data
directly to a computer; see Appendix B for more information. The options are
9600, 19.2K, 38.4K, and 57.6K.
ANALOG
Use this option to calibrate an analog device (chart recorder, polysomnography
machine, etc.). The options are 0.0V, 0.5V, and 1.0V. See Appendix B for more
detailed information.
MODE
Use this option to select between SpO
you select determines the data and format used for printer and modem output.
The mode also determines whether an alarm condition will cause a trend display
screen to revert to the waveform screen.
OUTPUT
Use this option to select 6-second or 30-second interval formats when printing data.
6 sec (second) output specifies the following:
30 sec (second) output specifies the following for trend data:
CONTRAST (3900P printer only)
If you have the 3900P, this option allows you to adjust the print quality of the
printer output. The options are 1, (lightest print) through 10 (darkest print). Press
the – or + function key to decrease or increase, respectively, the print quality.
2-16
When enabled (YES), you can press the alarm silence button three times
(within 3 seconds) and silence the alarms until you press the alarm silence
button again (or the unit is powered off).
When disabled (NO), you cannot silence the alarms continuously.
Trend data: every data point for SpO
Current data: lowest data point for SpO
6 seconds.
SpO : the lowest data point out of every 5.
2
PI : the average of 5 data points.
r
or PI pulsatile value modes. The mode
2 r
or PI data.
2 r
and the average PI
2
value for that
r