6/Maintenance And Service; Cleaning; Oximeter (With Or Without The Printer) - GE TruTrak+ 3900 User Manual

6/Maintenance and Service

This chapter covers
•
•
•
To replace the paper roll in the printer, see chapter 4.

Cleaning

To clean the modem, refer to the instructions for the modem you are using. To
clean a reusable sensor, refer to the instructions for the sensor.

Oximeter (with or without the printer)

WARNING: Electrical shock and flammability hazard. Before cleaning the oximeter, always turn
it off and disconnect the power cord from the AC power supply.
CAUTION:
•
•
•
•
Be sure that the oximeter is turned off and unplugged from the AC power supply
before cleaning and that the unit is completely dry before use.
To clean the display panel, use a cotton swab moistened with 70% isopropyl
alcohol and gently wipe the panel.
Maintenance procedures:
Cleaning the oximeter, as necessary.
Recharging the battery, as necessary.
Replacing the fuses in the power module, as necessary.
The Datex-Ohmeda repair policy.
A list of items you may order for the oximeter.
Do not autoclave, pressure sterilize, or gas sterilize this oximeter.
Use cleaning solution sparingly. Do not soak or immerse the monitor in liquid. Excessive
solution can flow into the monitor and damage internal components.
When cleaning the display area, do not use abrasive cleaning compounds or other materials
that could damage the screen.
Do not use petroleum-based solutions, acetone solutions, or other harsh solvents to clean
the oximeter. These substances may damage the oximeter and cause a malfunction.
6-1