Table of Contents
Advertisement
Precautions when unpacking
Material delivered in cardboard packaging
•
Small, lightweight, easy
to handle materiel
In this case, the products can be easily handled
without any lifting gear, taking care to position the
product according to the directional arrows on the
packaging.
In the absence of arrows indicating the top and
bottom, use the position of the various product
identity labels which are always placed at the top.
Dismounted material
These products are delivered unassembled.
The various elements are protected by the following types of packaging :
– plastic (vinyl) packaging
– bubble fi lm packaging / foam or polystyrene
– cardboard packaging.
Storage condition
Ambient Temperature Range :
Relative Humidity :
Atmospheric Pressure :
The following conditions must be observed when
storing any material :
– The area must be clean, well ventilated
and be of a normal temperature.
– Store products away from the elements,
and away from direct sunlight.
– The area must not be damp.
Conditions of use
– Dry and temperate area.
– Maximum altitude : 2000 m
Unpacking / Installation
When installing, remove all staple clips and carefully
remove the cardboard packaging. Fragile parts of
the product (upholstery coverings, plastic casings,
etc.) may be just below the packaging. Care must be
taken with cutting instruments.
Once the packaging has been removed, remove any
remaining protective covering.
6
•
Heavy or cumbersome material requiring the
use
of lifting gear
In this case, it is possible to use a fork lift truck,
provided it is used correctly.
Before moving, ensure the material is properly
positioned, and that the load is evenly balanced.
-15 °C to +60 °C (+5 °F to 140 °F)
10 % à 90 % (non-condensing)
0.5 bar to 1.05 bar (500 hPa to 1050 hPa)
– The products must not be subject to
bumps or jolts.
– Do not store in an area where people are
likely to pass.
– Articles must not be stacked on top of
each other.
– Articles must remain in their original
packaging until fi nal delivery.
– Temperature 10 to 40' C
– Relative humidity 75% maxi.
In the case of packaging on a wooden palette,
remove the packaging as above. Depending on the
model, the product is fi xed either by screwed fl
anges, or by nailed wooden stakes. Use a spanner
(for metal fl anges). Use a claw hammer (for wooden
stakes). Lift the article off the palette, and remove
the remaining protective covering. The product is
now ready for use.
User's Guide
Advertisement
Table of Contents
